Descrizione
The ic485IP Interface Converters provide asynchronous conversion between RS-232 interface and RS-485 standard interface.
The RS-232 interface connection is via the unit's DB-25 female connector, while the RS-485 side's connection is via either a five screw terminal block or an RJ-45.
The ic485IP converter's circuitry is not electrically isolation between the RS-232 and RS-485 sides.
The RS-232 side may operate as DTE or DCE, has provisions for establishing hardware flow control, and has LEDs to indicate data transmission and reception.
The RS-485 side may operate in either two wire half duplex or four wire half or full duplex and also has LED's to indicate data transmission and reception.
The RS-232 interface connection is via the unit's DB-25 female connector, while the RS-485 side's connection is via either a five screw terminal block or an RJ-45.
The ic485IP converter's circuitry is not electrically isolation between the RS-232 and RS-485 sides.
The RS-232 side may operate as DTE or DCE, has provisions for establishing hardware flow control, and has LEDs to indicate data transmission and reception.
The RS-485 side may operate in either two wire half duplex or four wire half or full duplex and also has LED's to indicate data transmission and reception.
Caratteristiche
- Electrically converts ASYNC RS-232 to RS-485/422
- Baud rate up to 128kbps
- DCE/DTE switch selectable
- RTS/CTS control, full/half duplex
- Simulation/monitor select switch
Codici d'Ordine
Modelli Disponibili
ic485IP-1: Async RS232 (DB25F) to RS422/485, 4-Screw Terminal Block, DC In 9V / 300mA